***SHOP SAFELY WITH CRAFT.COM.AU***GOOD QUALITY PRODUCTS AT BEST PRICES.***PERSONAL SERVICE***FLAT RATE SHIPPING IN AUSTRALIA***

Call Us: +61 414 610 408

From 9am-5pm AEST

Shopping Cart
Jo Sonja Decoupage Varnish 250ml

Jo Sonja Decoupage Varnish 250ml

$15.33
Jo Sonja’s Decoupage Varnish 250 mlDecoupage Varnish is a heavy-bodied version of Gloss Varnish for artists who wish to finish their projects with a thick, lacquelike coating. It has been specially formulated for decoupage artists to hide the cut edges of paper. Applying 8 to 10 coats of...

Description
Jo Sonja’s

Decoupage Varnish 250 ml

Decoupage Varnish is a heavy-bodied version of Gloss Varnish for artists who wish to finish their projects with a thick, lacquelike coating. It has been specially formulated for decoupage artists to hide the cut edges of paper. Applying 8 to 10 coats of Decoupage Varnish is equivalent to 35 to 40 coats of other, thinner varnishes.

Decoupage Varnish dries to a thick, glossy finish that does not yellow over time. It mat be used both indoors and outdoors to provide maximum long-term protection and when cured is corrosion, chemical, scratch and wear resistant.

For Decoupage :

All Purpose Sealeror Clear Glaze Medium may be used for adhesion of decoupage paper to the surface.

  • For large areas, a coat of All Purpose Sealer applied to the back of the paper and allowed to dry may decrease bubbles during application. Repeat on paper front. Allow to dry.
  • Bubbles may be avoided if paper is brushed lightly with water to moisten prior to application. Apply All Purpose Sealer thinned with Flow Medium 1:1 or Clear Glaze Medium to the surface and the back of the paper.
  • Begin to press the paper against the surface from the centre out to work out air bubbles. A soft cloth and a circular motion are recommended.
  • Lock down by gently using a brayer or wallpaper roller.

    Directions :

  • A coat of Clear Glaze Medium is recommended as a barrier coat prior to varnishing.
  • Gently shake the varnish and apply undiluted to the surface. If thinning is necessary for the first coats, add a few drops of Flow Medium, Retarder or Distilled Water to thin slightly. Do not over-dilute.
  • Apply Decoupage Varnish in a criss-cross motion using a soft but firm brush suitable to surface size.
  • Smooth by brushing final strokes in the direction of the wood grain. Avoid overlaps or drips along the edges.
  • Allow to air dry a minimum of an hour before applying additional coats. Drying time depends on the number of coats applied, climate and humidity. A hair dryer may be used to speed surface drying. Avoid excessive heat which could cause crazing.
  • A minimum of 8 to 10 coats will be required to hide the edges of the paper.
  • Allow varnished item to cure a minimum of two weeks before use. Cure time varies due to climate and humidity.

    Not recommended for use over oil based paint or oil based antiquing finishes.

    Approximate Coverage: 1 ml = 188 sq cm / 1 oz = 6 sq ft.

  • Back to Top